Filter
Top Products
C
B
A
Figure 28-25
Installing the cable (cable (PWR))
- For the cable (SIG), install the connector that has a threaded hole to the
terminal board.
Usethescrewthatwasremovedfromthesamelocationbefore.Tightenthe
screw with a Phillips screwdriver (bit No. 1). When installing the connector,
orient the connector so that the dot mark (A in the figure) is on the left as
shown in Figure 28-26.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
December 2013446