Filter
Top Products
Figure 28-23
Removing the cable (cable (SIG))
28.5 Installing the Cable Kit
This section describes the procedure for installing the cable kit at each cable
connection destination.
For the cable connection destinations, see "28.1 Configuration of the Cable Kit."
Install a cable that has the same shape as the removed cable.
28.5.1 Installing a cable between the crossbar backplane
unit and terminal board
Install the cable (SIG) or cable (PWR) connecting the crossbar backplane unit and
terminal board.
1.
Connect the cable to the connector of t he c rossbar backplane unit.
Install the cable that has the same shape as the removed cable.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
December 2013444