Filter
Top Products
146 Configuring System Information
Figure 6-37. Optical Transceiver Diagnostics
The Optical Transceiver Diagnostics page contains the following fields:
•
Interface
— The port IP address on which the cable is tested.
•
Temperat ure
— The temperature (C) at which the cable is operating.
•
Voltage
— The voltage at which the cable is operating.
•
Current
— The current at which the cable is operating.
•
Output Power —
The rate at which the output power is transmitted.
•
Input Power
— The rate at which the input power is transmitted.
•
Transmitter Fault —
Indicates if a fault occurred during transmission.
•
Loss of Signal
— Indicates if a signal loss occurred in the cable.
•
Data Ready
— Indicates the transceiver has achieved power up and data is ready.
Note: Finisar transceivers do not support the transmitter fault diagnostic testing. Fiber Optic analysis feature
works only on SFPs that support the digital diagnostic standard SFF-4872.
Displaying Optical Transceiver Diagnostics Test Results Table
1.
Open the
Optical Transceiver Diagnostics
page.
2.
Click
Show All
.
3.
Select the desired unit from the drop-down menu.