Filter
Top Products
Configuring IPv6 611
•
Dead Interval
(secs)
— The OSPF dead interval for the virtual link in units of seconds. This specifies
how long a router waits to see a neighbor router's Hello packets before declaring that the router is
down. This parameter must be the same for all routers attached to a common network, and should be
a multiple of the Hello Interval (i.e. 4).
•
Retransmit Interval (secs)
— The OSPF retransmit interval for the virtual link in units of seconds.
This specifies the time between link-state advertisements for adjacencies belonging to this router
interface. This value is also used when retransmitting database descriptions and link-state request
packets.
•
Interface Delay Interval (secs)
— The OSPF Transit Delay for the virtual link in units of seconds. It
specifies the estimated number of seconds it takes to transmit a link state update packet over this
interface.
Displaying OSPFv3 Virtual Link Summary using the CLI Command
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• OSPFv3 Commands
OSPFv3 Route Redistribution Configuration
Use the OSPFv3 Route Redistribution Configuration
page to configure route redistribution.
To display the page, click IPv6 > OSPFv3 > Route Redistribution Configuration in the tree view.
Figure 10-30. OSPFv3 Route Redistribution Configuration