Filter
Top Products
Configuring Switching Information 357
•
LAGs
— Displays and assigns multicast group membership to LAGs. To assign membership, click in
Static
for a specific LAG. Each click toggles between S, F, and blank. See the following table for
definitions.
The following table contains definitions for port/LAG IGMP management settings.
Adding Bridge Multicast Addresses
1.
Open the
Bridge Multicast Group
page.
2.
Click
Add
.
The
Add Bridge Multicast Group
page displays.
Table 7-2. Port/LAG IGMP Management Settings
Port Control Definition
D Dynamic: Indicates that the port/LAG was
dynamically joined to the Multicast group
(displays in the
Current
row).
S Static: Attaches the port to the Multicast group
as a static member in the
Static
row. Displays in
the
Current
row once Apply Changes is clicked.
F Forbidden: Indicates that the port/LAG is
forbidden entry into the Multicast group in the
Static
row. Displays in the
Current
row once
Apply Changes is clicked.
Blank Blank: Indicates that the port is not attached to a
Multicast group.