Filter
Top Products
Configuring System Information 241
– OPR Standby — Indicates that this unit is operating as the Standby Unit and the configured
Standby Unit is not part of the stack.
– CFG Standby — Indicates that the unit is configured as the Standby Unit. The unit configured as
the Standby switch becomes the stack manager if the current manager fails.
– Blank — Indicates that the switch is not configured as the Standby Unit.
•
Unit Type
— This field indicates whether the switch is configured as the management switch, the
standby switch, or a stack member.
•
Pre-configured Model Identifier
— This field displays the 16-character field assigned by the device
manufacturer to identify the pre-configured device.
•
Plugged-in Model Identifier
— This field displays the 16-character field assigned by the device
manufacturer to identify the plugged-in device.
•
Switch Status
— Indicates the unit status. There are five possible state values:
– OK — The unit is in place and functioning properly.
– Unsupported — The unit is not allowed to stack.
– Code Mismatch — The software image in this unit does not match that being used in the master
switch of the stack.
– Config Mismatch — The configuration file in this unit do not match that being used in the
master switch of the stack.
– Not Present — The unit is not there.
•
Firmware Version
— Indicates the detected version of code on this unit.
Viewing Stack Summary Using the CLI Command
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• System Management Commands
Supported Switches
Use the Supported Switches page to view information regarding each type of supported switch for
stacking, and information regarding the supported switches.
To displ ay t he Supported Switches page, click System > Stacking > Supported Switches in the tree
view.