Filter
Top Products
516 Configuring Routing
The drop-down menu lists the ACLs configured through the pages under
Switching
→
Network
Security
→
Access Control Lists
→
IP Access Control Lists
. When used for route filtering, the only
fields in an access list that get used are:
– Source IP Address and netmask
– Destination IP Address and netmask
– Action (Permit or Deny)
All other fields (source and destination port, precedence, tos, etc.) are ignored.
The source IP address is compared to the destination IP address of the route. The source IP netmask in
the access list rule is treated as a wildcard mask, indicating which bits in the source IP address must
match the destination address of the route.
NOTE:
A 1 in the mask indicates a Don’t Care in the corresponding address bit.
When an access list rule includes a destination IP address and netmask (an extended access list), the
destination IP address is compared to the network mask of the destination of the route. The
destination netmask in the access list serves as a wildcard mask, indicating which bits in the route’s
destination mask are significant for the filtering operation.
•
Redistribute
— Enables or disables the redistribution for the selected source protocol. This field has to
be enabled in order to be able to configure any of the route redistribution attributes.
Creating a Configured Source
1.
Open the
RIP Route Redistribution Configuration
page.
2.
Select an Available Source to configure.
3.
Specify values for the remaining fields.
4.
Click
Apply Changes
.
The specified Source is now configured, and the device is updated.
Modifying a Configured Source
1.
Open the
RIP Route Redistribution Configuration
page.
2.
Select the Configured Source to modify.
3.
Change values on this screen as needed.
4.
Click
Apply Changes
Specified changes are saved, and the device is updated.
Configuring RIP Route Redistribution using CLI Command
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• Routing Information Protocol (RIP) Commands