Filter
Top Products
Configuring Switching Information 351
Adding a LAG Port to an LACP
1.
Open the
LAG Membership
page.
2.
Click in the
LACP
row to toggle the desired LAG port to
L
.
Note: The port must be assigned to a LAG before it can be aggregated to an LACP.
3.
Click
Apply Changes
.
The LAG port is aggregated to the LACP, and the device is updated.
Assigning Ports to LAGs and LACPs Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• Port Channel Commands
LAG Hash Configuration
Use the LAG HASH algorithm to set the traffic distribution mode on the aggregator link. You can set the
HASH type for each trunk.
To displ ay t he LAG Hash Configuration page, click Switching > Link Aggregation > LAG Hash
Configuration in the tree view.
Figure 7-71. LAG Hash Configuration
The LAG Hash Configuration page contains the following fields:
•
LAG
— The drop-down menu lists the LAG numbers.
•
Hash Algorithm Type
— The HASH algorithm for unicast traffic flows can be one of the following
types: