Filter
Top Products
604 Configuring IPv6
The OSPFv3 Neighbor Table page displays the following fields:
•
Interface
— Selects the interface for which data is to be displayed or configured.
•
Neighbor Router ID
— A 32-bit integer in dotted decimal format representing the neighbor interface.
•
Priority
— The priority of this neighbor in the designated router election algorithm. A value of 0
indicates that the neighbor is not eligible to become the designated router on this network.
•
IntlfID
— The Interface ID that the neighbor advertises in its Hello packets on this link.
•
Interface
— The slot/port that identifies the neighbor interface index.
•
State
— State of the relationship with this neighbor.
•
Dead Time
— Number of seconds since last Hello was received from adjacent neighbors. Set this value
to 0 for neighbors in a state less than or equal to Init.
Displaying the OSPFv3 Neighbor Table
1.
Open the
OSPFv3 Neighbor Table
page.
2.
Select the interface to display from the
Interface
drop-down menu.
The OSPF neighbor table for the selected interface displays.
Displaying the OSPFv3 Neighbor Table using the CLI Command
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• OSPFv3 Commands