Filter
Top Products
316 Configuring Switching Information
Figure 7-42. STP LAG Table
3.
To change the STP settings for one or more LAGs, select the Edit option for the LAG(s), configure the
desired settings, and then click
Apply Changes
.
Defining STP LAG Settings Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• Spanning Tree Commands
Rapid Spanning Tree
Rapid Spanning Tree Protocol (RSTP) detects and uses network topologies that allow a faster
convergence of the spanning tree without creating forwarding loops.
To displ ay t he Rapid Spanning Tree page, click Switching > Spanning Tree > Rapid Spanning Tree in
the tree view.
Figure 7-43. Rapid Spanning Tree
The Rapid Spanning Tree page contains the following fields:
•
Interface
— Determines if RSTP is enabled on a Unit/Port or on a LAG. Click Unit/Port or LAG to
specify the type of interface, then select the Unit/Port or LAG to configure from the drop-down menu.
•
State
— Displays the spanning tree state for the port.