Filter
Top Products
548 Configuring Routing
Removing a Tunnel
1.
Open the
Tunnels Configuration
page.
2.
Specify the tunnel to remove in the
Tunnel
drop-down menu.
3.
Click
Delete Tunnel
.
The tunnel is deleted, and the device is updated.
Configuring a Tunnel using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• Tunnel Interface Commands
Tunnels Summary
Use the Tu nnel s Summary
page to display a summary of configured tunnels. To display the page, click
Routing > Tunnels > Summary in the tree view.
Figure 9-55. Tunnels Summary
The Tunnels Summ ar y page contains the following fields:
•
Tunnel ID
— The Tunnel ID.
•
Tunnel Mode
— The corresponding mode of the Tunnel.
•
IPv6 Mode
— Shows whether IPv6 is enabled on the tunnel.
•
Source
— The corresponding Tunnel Source Address. In the case where an interface has been
configured both the interface and the address are displayed. If the source interface has no address
configured then nothing is displayed in place of the address.
•
Destination
— The corresponding Tunnel Destination Address.
•
Tunnel ID
— The Tunnel ID.