Filter
Top Products
706 Configuring IP Multicast
The PIM Interface Summary page contains the following fields:
•
Interface
— Select the interface for which data is to be displayed. There must be configured at least
one router interface before displaying data for a PIM interface, otherwise an error message displays.
Interface Parameters fields are:
•
Admin Mode
— Displays the administrative status of PIM for the selected interface.
•
Protocol State
— The operational state of the PIM protocol on this interface.
•
IP Address
— The IP address of the selected interface.
•
Hello Interval
— The frequency (in seconds) at which PIM hello messages are transmitted on the
selected interface.
•
Join/Prune Interval
— The frequency (in seconds) at which PIM Join/Prune messages are transmitted
on this PIM interface.
•
DR Priority
— Indicates the DR priority on the PIM interface. This field is supported in PIM-SM only.
•
BSR Border
— Specifies the BSR border mode on the PIM interface. This field is not supported for
PIM-DM.
•
Designated Router
— The designated router on the selected PIM interface. For point-to-point
interfaces, this is 0.0.0.0.
Interface Neighbors fields are:
•
Neighbor Count
— The number of PIM neighbors on the selected interface.
•
Neighbor IP
— The IP address of the PIM neighbor for which this entry contains information.
•
Up Time
(hh:mm:ss) — The time since this PIM neighbor (last) became a neighbor of the local router.
Expiry Time
(hh:mm:ss) — The minimum time remaining before this PIM neighbor is aged out.
Displaying PIM-DM Interface Summary using the CLI Command
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• PIM-DM Commands