Filter
Top Products
Configuring IP Multicast 679
Configuring DVMRP using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• DVMRP Commands
DVMRP Interface Configuration
Use the DVMRP Interface Configuration
page to configure a DVMRP interface. You must configure at
least one router interface before you configure a DVMRP interface. Otherwise you see a message telling
you that no router interfaces are available, and the configuration screen is not displayed.
To display the page, click IP Multicast > DVMRP > Interface Configuration in the tree view.
Figure 12-20. DVMRP Interface Configuration
The DVMRP Interface Configuration page contains the following fields:
•
Interface
— Select the interface for which data is to be configured. You must configure at least one
router interface before you configure a DVMRP interface.
•
Interface Mode
— Select Enable or Disable from the drop-down menu to set the administrative mode
of the selected DVMRP routing interface.
•
Interface Metric
— Enter the DVMRP metric for the selected interface. This value is sent in DVMRP
messages as the cost to reach this network. Valid values are from 1 to 31.