Filter
Top Products
284 Configuring Switching Information
–
Assign ACL Priority
— Assigns the priority of this ACL. If more than one ACL is applied to an
interface, then the match criteria for the highest priority ACLs are checked first.
Assigning an ACL to an Interface
1.
Open the
ACL Bind Configuration
page.
2.
In the
Interface
field, specify the Unit and Port, LAG, or VLAN to configure.
3.
Select the IP, IPv6, or MAC ACL in the
Select an ACL
field.
Note:
Whenever an ACL is assigned on a port, LAG, or VLAN, flows from that ingress interface
that do not match the ACL are matched to the default rule, which is Drop unmatched packets.
4.
Specify the priority in
Assign ACL Priority
.
5.
Click
Apply Changes
.
The ACL is attached to the specified interface(s).
Removing an Interface from an ACL
1.
Open the
ACL Bind Configuration
page.
2.
Click
Show All
.
3.
In the Interface field, specify the Unit and Port, LAG, or VLAN to view the ACL bindings for that
interface.
4.
Select the
Remove
check box for one or more ACLs to remove.
5.
Click
Apply Changes
.
The specified ACL(s) are removed from the interface.
Assigning ACL Membership Using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• ACL Commands