Filter
Top Products
666 Configuring IP Multicast
•
Query Max Response Time (secs)
— Enter the maximum query response time to be advertised in
MLDv2 queries on this interface, in ms. The default value is 10000. Valid values are 0 to 65535
milliseconds (ms).
•
Last Member Query Interval
— Enter the maximum response time inserted into group-specific
queries sent in response to leave group messages. This value is also the amount of time between group-
specific query messages. This value may be tuned to modify the leave latency of the network. Valid
values are 0 to 65535 milliseconds (ms). The default is 1000.
•
Last Member Query Count
— The number of queries to be sent on receiving a leave group report.
Valid values are 1 to 20. The default is 2.
MLD Routing Interface Summary
Use the MLD Routing Interface Summary page to display information and statistics on a selected
MLD-enabled interface. You must configure at least one IGMP router interface to access this page.
To access this page, click IPv6 Multicast > MLD > Routing Interface > Interface Summary in the
navigation tree.
Figure 12-11. MLD Routing Interface Summary