Dell M8024 Network Card User Manual


 
Configuring System Information 187
CP Global Configuration
From the CP Global Configuration page, you can control the administrative state of the CP feature and
configure global settings that affect all captive portals configured on the switch.
To configure the global CP settings, click System > Captive Portal > Global Configuration.
Figure 6-68. CP Global Configuration
The CP Global Configuration page contains the following fields:
Captive Portal
— Enable or disable the CP feature on the switch.
CP Global Operational Status
— Shows whether the CP feature is enabled.
CP Global Disable Reason
— If CP is disabled, this field displays the reason, which can be one of the
following:
–None
Administrator Disabled
–No IPv4 Address
Routing Enabled, but no IPv4 routing interface
Additional HTTP Port
— HTTP traffic uses port 80, but you can configure an additional port for
HTTP traffic. Enter a port number between 0-65535 (excluding ports 80, 443, and the configured
switch management port).
Additional HTTP Secure Port
— HTTP traffic over SSL (HTTPS) uses port 443, but you can
configure an additional port for HTTPS traffic. Enter a port number between 0-65535 (excluding ports
80, 443, and the configured switch management port).