Filter
Top Products
Configuring Dell PowerConnect 67
Booting the Switch
When the power is turned on with the local terminal already connected, the switch goes through Power
On Self Test (POST). POST runs every time the switch is initialized and checks hardware components to
determine if the switch is fully operational before completely booting.
If a critical problem is detected, the program flow stops. If POST passes successfully, a valid executable
image is loaded into RAM.
POST messages are displayed on the terminal and indicate test success or failure.
To boot the switch, perform the following steps:
1.
Ensure that the serial cable is connected to the terminal.
2.
Connect the power supply to the switch.
3.
Turn on th e s witch.
As the switch boots, the boot test first counts the switch memory availability and then continues to
boot.
4.
During boot, you can use the
Boot
menu, if necessary to run special procedures. To enter the
Boot
menu, press
2
within the first ten seconds after the following message appears.
Select an option. If no selection in 10 seconds then
operational code will start.
1 - Start operational code.
2 - Start Boot Menu.
Select (1, 2):2
For information about the
Boot
menu, see "Boot Menu Functions." The following text is an example of
the entire displayed POST:
CPU Card ID: 0x508548
Mounting TFFS System ...
Device details...
volume descriptor ptr (pVolDesc): 0x1ae4898
XBD device block I/O handle: 0x10001
auto disk check on mount: NOT ENABLED
volume write mode: copyback (DOS_WRITE)
max # of simultaneously open files: 22