Filter
Top Products
XG2000 series User's Guide
121/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.7.2 show bridge
Function
Displays the basic function configuration of the switch.
Prompt
xg> or xg#
Command syntax
show bridge
Command type
Operation management commands
Output form
xg# show bridge
Switch Basic Information 2007/01/22-12:12:15
===============================================================================
Aging Time : {Disabled | <10-1756> } (sec)
Cut-through Switching : {Disabled | Enabled }
Jumbo Frame Support
: {Disabled | Enabled Max Frame Size: 9216 (byte) }
Independent-vlan-learning
: {Disabled | Enabled }
DiffServ ToS : {Disabled | Enabled }
===============================================================================
z Aging Time
Displays the ageing time of the MAC address entries.
− Disabled
Aging is disabled.
− <10-1756> (sec)
Aging time (the time until a dynamically-learned MAC address expires) is displayed.
z Cut-through Switching
The switching state is displayed.
− Disabled
The switching method is store-and-forward.
− Enabled
The switching method is cut-through.
z Jumbo Frame Support
The jumbo frame support state is displayed.
− Disabled
Jumbo frames are not forwarded.
− Enabled Max Frame Size
Displays the maximum size of a jumbo frame that will be forwarded.
z Independent-vlan-learning
The IVL (Independent Vlan Learning) is displayed.
− Disabled
The learning mode is SVL (Shared Vlan Learning).
− Enabled
The learning mode is IVL (Independent Vlan Learning).
z DiffServ ToS
The DiffServ state based on ToS is displayed.
− Disabled
DiffServ is disabled.
− IPv4
DiffServ of IPv4 is enabled.
− IPv6
DiffServ of IPv6 is enabled.
Example
Display the basic function configuration of the switch.
xg# show bridge