Filter
Top Products
XG2000 series User's Guide
75/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.4.4 configure terminal
Function
Switch from the administrator exec mode to the global configuration mode.
Prompt
xg#
Command syntax
configure terminal
Command type
Operation management commands
Message
Configuration is locked by other.
Explanation
A switch in state is not possible because a terminal session in global configuration
mode exists.
Solution
After switching the terminal session from global configuration mode to administrator
EXEC mode, re-execute the command.
Example
Switch from the administrator exec mode to the global configuration mode using the "configure terminal" command.
The prompt character will change to "xg(config)#."
xg# configure terminal
xg(config)#
5.4.5 exit
Function
Returns to the prior command mode level.
The relationship between the current command mode and the command mode status after executing the "exit" command is as
follows:
Current command mode Status after exit
Operator exec mode Log out
Administrator exec mode Log out
Global configuration mode Administrator exec mode
Interface Global configuration mode
Terminal edit mode Global configuration mode
Prompt
xg>, xg#, xg(config)# , xg(config-if)# , xg(config-agg)# , xg(config-vlan)# , xg(config-line)#
Command syntax
Exit
Command type
Operation management commands
Example
Switch from the global configuration mode to the administrator exec mode using the "exit" command.
The prompt character will change to "xg#."
xg#(config)# exit
xg#