Filter
Top Products
XG2000 series User's Guide
283/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
Message ID
Severity
Message/Explanation/Solution
S0124
Info
Internal Temperature is high. (%1$ %2$)
Explanation
The temperature is high. The system will be shut down if the temperature rises.
z [[Inserted string]]%1$, %2$: Temperature value
Solution
Perform the following checks on the device:
z Check that the air vent is not blocked.
z Check the temperature of the switch environment is within the limits specified.
S0125
CRITICAL
Shutdown the system because of high temperature alarm. (%1$ %2$)
Explanation
The system was shut down because of high temperature alarm.
z [[Inserted string]]%1$, %2$: Temperature value
Solution
Perform the following checks on the device:
z Check that the air vent is not blocked.
z Check the temperature of the switch environment is within the limits specified.
If the message is displayed even though the device was properly installed, note the message contents and
contact the sales representative.
S0126
ERROR
AC and DC PSUs are mounted.
Explanation
The device mounts both AC PSU and DC PSU.
Solution
AC PSU and DC PSU should not be mounted simultaneously.
Make sure to mount the same type of PSU.
A.2.2 kernel (Basic Control: 1000-1999)
Message ID
Severity
Message/Explanation/Solution
S1000
CRITICAL
Abnormal reset occurred (WatchDog Reset: code=%1$)
Explanation
The fault monitor control detected an error and rebooted the device.
z [[Inserted string]]%1$: Additional information that indicates the cause of the reset.
Solution
Obtain maintenance information using the "tftp put-maintenance
" or "scp put-maintenance" command after
restarting the system then note the message content before contacting the sales representative.
S1001
CRITICAL
MAC address in EEPROM is invalid.
Explanation
An error occurred in the device that stores the device's MAC addresses.
Solution
Note the message contents and contact the sales representative.
P1100
INFO
%1$: config: auto-negotiation on, %2$
Explanation
Management LAN auto-negotiation is being performed.
z [[Inserted string]]%1$: Name of target network interface
z [[Inserted string]]%2$: Displays supported features (speed and duplex).
P1101
INFO
%1$: status: link %2$
Explanation
The link status of the management LAN changed.
z [[Inserted string]]%1$: Name of target network interface
z [[Inserted string]]%2$: Displays details of the current link state.
S1900
CRITICAL
Core dumped %1$
Explanation
A critical firmware error was detected and a process dump was output.
z [[Inserted string]]%1$: Process number
Solution
Obtain maintenance information using the "tftp put-maintenance
" or "scp put-maintenance" command then
take note of the message content before contacting the sales representative.