Filter
Top Products
XG2000 series User's Guide
143/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
z Link Status Detail
Details of the port are displayed:
Display Meaning
PLUG-OUT The XFP is not installed.
LOW-PWR The XFP is in low power state.
PHY Access to the XFP failed.
CLI The shutdown command was executed.
TMR Since the shutdown command and link-aggregation command were executed, the port is
down for a certain period of time.
AGG-MIN The number of ports in a link up state comprising an aggregation group became less than
the minimum number of ports required to maintain a link up state.
LF A local fault was detected.
RF A remote fault was detected.
LPT A link down state notification through the link pass through function occurred.
SDL Frame discarding due to broadcast storm control was detected.
PSL Frame discarding due to a port security violation was detected.
LAL Frame discarding due to a loop back alert was detected.
SYS An internal system contradiction was detected.
z STP State
− Disabled
The port is in a state to discard data traffic.
− Learn
The port is in the learning state. It prepares for forwarding data traffic. It discards
data traffic.
− Forward
The port is ready to transmit data traffic.
z Flow Control
− Disabled
PAUSE flow control is disabled.
− Rx Only
Rx PAUSE flow control is enabled.
− Tx Only
Tx PAUSE flow control is enabled.
− Rx and TX
Rx and Tx PAUSE flow control is enabled.
z Address Learning
− Enabled
Dynamic MAC address learning is enabled.
− Disabled
Dynamic MAC address learning is disabled.
z Multicast Forwarding
− Forward-all
All multicast frames will be forwarded (flooded).
− Forward-unregistered-mac
Multicast addresses yet to be registered in the static MAC address table, and multicast
addresses registered will be forwarded (flooded).
− Filter-unregistered-mac
Only Multicast addresses registered in the static MAC address table will be forwarded.
z Port Security
− Shutdown
When a violating frame is detected, the port enters a violation state and goes link
down.
− Restrict
When a violating frame is detected, the port enters a violation state, and the violating
frame is discarded.
− Disabled
Port security is disabled.
z Storm Control
− Enabled
Broadcast storm control is enabled.
− Disabled
Broadcast storm control is disabled.
z Default Qos Priority
The QoS priority <0-7> is displayed.
z Qos Egress Scheduling
− Strict
Forwarding is scheduled using strict priority.
− DRR
Forwarding is scheduled using round robin.
− DRR-S
trict
Forwarding is scheduled using both strict priority and round robin.
z Qos
Bandwidth
Bandwidth for each output queue priority is displayed
z Ingress Bandwidth
The ingress rate limiting value of the port is displayed in Mbps.
For an aggregation group, the ingress rate limiting value total "(total:<240-60000>)," is
displayed.