Filter
Top Products
XG2000 series User's Guide
288/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
Message ID
Severity
Message/Explanation/Solution
S2226
WARNING
Too Many CM Buffer SBE Errors. LOG Disabled.
Explanation
A correctable error was repeatedly detected in the switch chip. Logging for this event is disabled.
Solution
Note the message contents and contact the sales representative.
S2401
ERROR
System Error: %1$
Explanation
A system error of Layer2 basic management module was detected.
z [[Inserted string]]%1$: Supplementary code for the error
Solution
Note the message contents and contact the sales representative.
A.2.4 npm (Network Protocol Control: 3000-3299)
Message ID
Severity
Message/Explanation/Solution
S3001
INFO
Cold Start or Warm Start.
Explanation
The system was turned on.
S3002
INFO
Link down %1$. (%2$)
Explanation
Port status changed from a link up to a link down state.
z [[Inserted string]]%1$: Information on the port whose status changed to a link down.
z [[Inserted string]]%2$: Cause of link down.
For details, refer to "Link Status Detail" of the "show interface" command.
S3003
INFO
Link up %1$.
Explanation
Port status changed to a link up state.
z [[Inserted string]]%1$: Information on the port whose status changed to link up.
S3004
WARNING
%1$ detected storm drop.
Explanation
A broadcast storm was detected.
z [[Inserted string]]%1$: Information on the port that dropped broadcast frames.
Solution
A loop topology may exist on the network. Review the network configuration.
S3005
WARNING
%1$ detected port security violation.
Explanation
A violating packet was detected by Port Security enabled.
z [[Inserted string]]%1$: Information on the port that detected the violating packet.
Solution
Investigate the cause for receiving violating packets.
S3006
WARNING
%1$ detected loopback alert.
Explanation
A packet loop was detected.
z [[Inserted string]]%1$: Information on the port that detected the loop.
Solution
A loop topology may exist on the network. Review the network configuration.
A loopback alert can occur when the destination MAC address of a received frame was registered in the MAC
address table with the receiving port registered as a destination. In other words, a loopback alert can occur even
if there is no loop in the network.
P3009
INFO
%1$ has been attached to %2$.
Explanation
The physical port was attached to a link aggregation group.
z [[Inserted string]]%1$: Physical port information
z [[Inserted string]]%2$: Aggregation group information
P3010
INFO
%1$ has been detached.
Explanation
The physical port was detached from a link aggregation group.
z [[Inserted string]]%1$: Information on physical port detached