Filter
Top Products
XG2000 series User's Guide
259/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.20.9 update-system
Function
Updates the firmware on the device.
The device stores two firmware images. This command updates the standby firmware. The updated firmware is made valid
after the next system startup.
Prompt
xg#
Command syntax
update-system local FILE-NAME
update-system { tftp | scp USERNAME } HOST REMOTE-FILE
Parameter
z local FILE-NAME
Specifies the firmware image file that was downloaded from the TFTP server to non-volatile
memory in the device.
z tftp
Directly updates the firmware from the firmware image file stored on the TFTP server.
z scp USERNAME
Specifies the username of the SSH server.
z HOST
Specify the host name or the IP address of the TFTP server or SSH server.
The IP address must be within the range of 1.0.0.1 to 126.255.255.254, 128.0.0.1 to
191.255.255.254, or 192.0.0.1 to 223.255.255.254.
z REMOTE-FILE
Specifies the firmware image file residing on the TFTP server or SSH server.
Command type
Operation management command
Message
% File not found.
Explanation
The specified file was not found.
Solution
Check the file name for an error.
% Reading the file failed.
Explanation
The specified file could not be read.
Solution
Check that the file is read enabled.
% Checksum error: %1$ in the file
Explanation
A data error was detected in the specified file.
[[Inserted string]]%1$: Firmware configuration module
Solution
Check the file for an error in its contents.
If the file contents are OK, an error may have occurred during file transmission. Transfer
the file again.
% Checksum error: whole file
Explanation
A data error (a checksum error of the entire file) was detected.
Solution
Check the file for an error in its contents.
If the file contents are OK, an error may have occurred during file transmission. Transfer
the file again.
% Version of the format of the file is not suitable for this system.
Explanation
The firmware revision of the specified file cannot be used with the system hardware.
Solution
Specify the correct file to update the system firmware.
% The file is not for this system.
Explanation
The firmware revision of the specified file cannot be used with the system hardware.
Solution
Specify the correct file to update the system firmware.
% Reading boot loader partition in FlashROM failed.
Explanation
An error occurred during a read of flash ROM data.
Solution
Retry firmware updating.
If the error recurs, contact the sales representative.