Filter
Top Products
XG2000 series User's Guide
254/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.20.6 tftp put-maintenance
Function
Transfers the system maintenance information to a TFTP server.
The file size of the maintenance information is displayed on the screen.
Prompt
xg#
Command syntax
tftp put-maintenance HOST [ REMOTE-FILE ]
Parameter
z HOST
Specifies the host name or the IP address of the TFTP server.
The IP address can be within the range of 1.0.0.1 to 126.255.255.254, 128.0.0.1 to
191.255.255.254, or 192.0.0.1 to 223.255.255.254.
z REMOTE-FILE
Specifies the path and file name the maintenance information will reside in once transferred
to the TFTP server. If the file name is omitted, the following file name is generated
automatically:
"mainte_2007_01_31_13_30_59” (date and time when obtained).
Command type
Operation management command
Message
% tftp: %1$: Host name lookup failure
Explanation
The specified host name does not exist.
[[Inserted string]]%1$: Specified host name
Solution
Check the host name for an error.
% tftp: server says: %1$
Explanation
An error was reported from the TFTP server.
[[Inserted string]]%1$: Error messages sent from the FTP server
The message contents vary depending on the TFTP server type used. Typical messages are
as follows.
− File not found: No file is found on the TFTP server.
− Access violation: An error of file access authority occurred on the TFTP server.
− Not allowed to overwrite existing files: The file in the TFTP server cannot be overwritten.
− Could not open requested file for reading: There are no files in the TFTP server.
− File already exists: The specified file already exists on the TFTP server.
− Unknown transfer ID: The process is interrupted due to the timeout.
Solution
Take actions by following the message instructions sent from the TFTP server.
% tftp: last timeout
Explanation
There is no response by the TFTP server. The network communication with the management
LAN may have failed or too short a timeout was set on the TFTP server.
Solution
Issue a “ping” command to check the network connection to the TFTP server. If an error
recurs, change the timeout value of the TFTP server.
% Invalid IP-address.
Explanation
The IP address was specified in an incorrect format or an incorrect address was specified.
Solution
Specify the correct IP address in the correct format then reissue the command.
% Cannot find %1$
Explanation
An incorrect host name was specified.
[[Inserted string]]%1$: Specified host name.
Solution
.Specify the correct host name, or specify the IP address.
Note
z If the file or directory specified by REMOTE-FILE does not exist on the TFTP server, an error may occur (it depends on
the TFTP server functions).
z If too short a timeout was set on the TFTP server, an error may occur (it depends on the TFTP server functions).
z To ensure the transmission of all the maintenance information, compare the file size displayed on the screen and the
size of the file saved on the TFTP server.