Filter
Top Products
XG2000 series User's Guide
260/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
% Writing %1$ into FlashROM failed.
Explanation
An error occurred while writing to flash ROM.
[[Inserted string]]%1$: Firmware configuration module
Solution
Retry firmware updating.
If the error recurs, contact the sales representative.
% Checksum error: %1$ in FlashROM
Explanation
An error occurred while writing to flash ROM.
[[Inserted string]]%1$: Firmware configuration module
Solution
Retry firmware updating.
If the error recurs, contact the sales representative.
% %1$ in SRAM is invalid.
Explanation
An inconsistency in non-volatile (SRAM) memory data was detected.
[[Inserted string]]%1$: Abnormal memory contents
Solution
Restart the system using the "reset" command. Then, retry firmware updating.
If the error recurs, contact the sales representative.
% tftp: %1$: Host name lookup failure
Explanation
The specified host name does not exist.
[[Inserted string]]%1$: Specified host name
Solution
Check the host name for an error.
% tftp: server says: %1$
Explanation
An error was reported from the TFTP server.
[[Inserted string]]%1$: Error messages sent from the FTP server
The message contents vary depending on the TFTP server type used. Typical messages are
as follows.
− File not found: No file is found on the TFTP server.
− Access violation: A file access violation occurred on the TFTP server.
− Not allowed to overwrite existing files: The file in the TFTP server cannot be overwritten.
− Could not open requested file for reading: The file does not exist on the TFTP server.
− File already exists: There are files in the TFTP server.
− Unknown transfer ID: Process will be aborted in time out.
Solution
Take actions by following the message instructions sent from the TFTP server.
% tftp: write: No space left on device
Explanation
The non-volatile memory on the device has insufficient work area. A portion of the file
being downloaded may remain in the non-volatile memory.
Solution
Delete the downloaded file and unnecessary files on the system using the "delete" command.
Then, reissue the "update-system" command.
% tftp: last timeout
Explanation
There is no response from the TFTP server. The network may have failed or too short a
timeout was set on the TFTP server.
Solution
Issue a "ping" command to check the network connection to the TFTP server. If the error
recurs, change the timeout value on the TFTP server.
% Invalid IP-address.
Explanation
The IP address was specified in an incorrect format or an incorrect address was specified.
Solution
Specify the correct IP address in the correct format then reissue the command.
% Cannot find %1$
Explanation
An incorrect host name was specified.
[[Inserted string]]%1$: Specified host name.
Solution
.Specify the correct host name, or specify the IP address.
% The length of user name is invalid.
Explana
t
ion
The length of the username is invalid.
Solution
Specify the username 16 or less characters.
No more remote host public key can be registered.
Explanation
Specified remote host public key could not be registered.
Solution
Delete a public key by using "clear ssh-rhost key" command, then execute the command
again.