Filter
Top Products
XG2000 series User's Guide
204/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.15.17 ip snooping send-query-count
Function
Sets a query message transmission frequency.
Use the no form to return to the default setup.
Prompt
xg(config-vlan)#
Command syntax
ip snooping send-query-count <1-3>
no ip snooping send-query-count
Parameter
z send-query-count <1-3>
Sets a query message transmission frequency.
Command type
Configuration command
Default
2
Message
% Global IGMP snooping is not enabled.
Explanation
Global IGMP snooping on the device is disabled.
Solution
Enable global IGMP snooping using the “ip snooping protocol” command first then execute
the command again.
% IGMP snooping vlan-%1$ is not enabled.
Explanation
IGMP snooping of the specified VLAN is disabled.
[[Inserted string]]%1$: Specified VID
Solution
Enable IGMP snooping on the VLAN using the “ip snooping vlan” command first, then execute
the command again.
Example
Set the query message transmission frequency on VLAN 2 to 3:
xg(config)# interface vlan 2
xg(config-vlan)# ip snooping send-query-count 3