Filter
Top Products
XG2000 series User's Guide
209/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.16.2 monitor traffic-counts
Function
Displays the transmission frame count at each port.
Prompt
xg> or xg#
Command syntax
monitor traffic-counts { current | total } [interval <3-60>]
Parameter
z { current | total }
Specifies the statistics to be displayed.
− current
Displays the number of accumulated transmission frames after startup of this command.
− total
Displays the number of accumulated transmission frames after startup of the system.
z interval <3-60>
Specifies the update interval (in seconds).
The default interval is 3 seconds.
Command type
Operation management command
Output form (if "current" is specified)
xg# monitor traffic-counts current
Traffic Statistics(Current Frame Counts) 2007/01/22-12:12:15
===============================================================================>
Port Link State/ Tx-Frame Rx-Frame
Tx-Frame Rx-Frame Rx-Bcast
STP State Counts/S Counts/S Counts Counts
Counts
---- ---------- ---------- ---------- ---------- ------------ -----------
1 Up/Discard 12345678K 12345678K 1234567890K 1234567890K 1234567890K
2 Down 0
0 0 0 0
3 Up/Discard 923 923 1234567890K 1234567890K 1234567890K
4 Up/Learn 999123 999123 1234567890M 256M 256M
5 Up/Forward
999 999 1234567890G 256G 256G
6 Up/Forward 999999 999999 1234567890T 256T 256T
===============================================================================>
ESC:exit F:refresh
U:page up D:page down L:page left R:page right
(continues)
Traffic Statistics(Current Frame Counts) 2007/01/22-12:12:15
<=================================================================================
Rx-Mcast Port-Description
Counts
----------- ------------------------------------
1234567890K port_name1
0 port_name2
1234567890K port_name3
256M port_name4
256G port_name5
256T
<=================================================================================
ESC:exit F:refresh
U:page up D:page down L:page left R:page right
z Port
Displays the port numbers. Statistics for each port are displayed on one line.
z Link State/STP State
Displays the port state in the Link State or STP State format.
The Link State may indicate one of the following link states.
− Down
The port link is down.
− Up
The port link is up.
The STP State displays the current port status based on the STP (Spanning Tree Protocol).
Note that the STP State is not displayed if the Link State is down.
For port status details, see “Spanning Tree Protocol Port States
”.
z Tx-Frame Counts/S
Displays the transmission frame rate (in fps) using an 8-digit, right-justified value.
z Rx-Frame Counts/S
Displays the receive frame rate (in fps) using an 8-digit, right-justified value.
z Tx-Frame Counts
Displays the number of accumulated transmission frames after execution of this command, using
a 10-digit, right-justified value.
z Rx-Frame Counts
Displays the number of accumulated receive frames after execution of this command, using
a 10-digit, right-justified value.