Filter
Top Products
XG2000 series User's Guide
233/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.17 SNMP Setup Commands
This section explains the SNMP configuration settings.
5.17.1 show snmp-server
Function
Displays the current SNMP settings.
Prompt
xg> or xg#
Command syntax
show snmp-server
Command type
Operation management command
Output form
xg# show snmp-server
SNMP Information 2007/01/22-06:04:41
===============================================================================
SNMP Manager Information
-------------------------------------------------------------------------------
[No.1]
Host
: 192.168.41.24
Community
: public
[No.2]
Host : 192.168.41.29
Community
: public
-------------------------------------------------------------------------------
SNMP Trap Manager Information
-------------------------------------------------------------------------------
[No.1]
Host : 192.168.41.24
Community
: public
Version : { v1 | v2c }
[No.2]
Host
: 192.168.41.29
Community : public
Version
: { v1 | v2c }
===============================================================================
SNMP Manager Information
Displays the current settings of the SNMP manager.
z [No.1]
Indicates the number of the SNMP manager displayed. A maximum of four may be defined.
z Host
Displays the host name or the IP address of the SNMP manager.
z Community
Displays the community name of the SNMP manager.
SNMP Trap Manager Information
Displays the destination SNMP trap being set from the system.
z [No.1]
Indicates the number of the SNMP trap item displayed.
z Host
Displays the host name or the IP address of the SNMP manager for trap notification.
z Community
Displays the community name of the SNMP manager for trap notification.
z Version
Displays the SNMP protocol version to be used for trap notification as follows:
− v1
The SNMP v1 protocol is used for trap notification.
− v2c
The SNMP v2c protocol is used for trap notification.