Filter
Top Products
XG2000 series User's Guide
130/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.8 Link Aggregation Configuration Commands
This section explains the commands associated with link aggregation.
5.8.1 show link-aggregation
Function
Displays the state of an aggregation group.
Prompt
xg> or xg#
Command syntax
show link-aggregation [ agg-port <1-10> ]
Parameter
z agg-port <1-10>
Specifies the aggregation group number. The value can be set in the range of 1 to 10.
When this parameter is omitted, the state of all aggregation groups will be displayed.
Command type
Operation management commands
Output form (in case of static link aggregation)
xg# show link-aggregation
Link Aggregation Information 2007/01/22-14:30:35
===============================================================================
System Priority : 32768
System ID
: 0080.17c2.2144
-------------------------------------------------------------------------------
[agg-port 1]
Master port
: port <1-20>
Management packet send port : port <1-20>
Mac address : 0080.17c2.2144
Protocol : None
Distribution algorithm : { Destination address | Source address
| Destination address & Source address
| Vlan | IP Hash }
{ Destination IP | Source IP
| Destination port | Source port }
Distribution parameter
: <0-3>
The minimum number of ports : 1
[port 1]
Port Status : {Active | Inactive }
[port 2]
Port Status : {Active | Inactive }
-------------------------------------------------------------------------------
[agg-port 2]
================================================================================
Link aggregation group common information
Link aggregation information related to the switch in general will be displayed.
z System Priority
The system priority used by LACP is displayed.
z System ID
The identification information used by LACP is displayed.
The state of each aggregation group will be displayed.
[agg-port 1]
Indicates the aggregation group number being displayed.
z Master port
Displays the master port number of the aggregation group.
Of the ports belonging to a link aggregation group, the one with the smallest port number
will be the master port.
z Management packet send port
The port number, transmitting the control protocol between switches such as BPDU and IGMP,
are displayed.
Normally, of the ports belonging to an aggregation group, the one with the smallest port
number among the ports in a link up state will be the management packet send port.
z Mac address
Displays the MAC address of the aggregation group. This MAC address will be the same value
as that of the master port.