Filter
Top Products
XG2000 series User's Guide
181/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.13.2 qos default-priority
Function
Sets the default priority for frames having no priority information (such as VLAN untagged frames).
Use the no form to return to the default setup.
Prompt
xg(config-if)# or xg(config-agg)#
Command syntax
qos default-priority <0-7>
no qos default-priority
Parameter
z default-priority <0-7>
Sets the default priority for frames having no priority information.
Command type
Configuration command
Default
0
Example
Enter the interface edit mode for switch ports 1 and 3, and set the default priority to 1.
xg(config)# interface port 1 3
xg(config-if)# qos default-priority 1
5.13.3 qos-map priority
Function
The system has four priority levels of output queues for frame transmission processing.
This command maps the frame priorities to the output queue levels.
Use the no form to reset the entire mapping information to the default setup.
Prompt
xg(config)#
Command syntax
qos-map priority <0-7> output-priority <0-3>
no qos-map
Parameter
z priority <0-7>
Specifies a frame priority within the range of 0 to 7.
z output-priority <0-3>
Specifies the output queue level to be associated with the specified priority within the
range of 0 to 3.
Command type
Configuration command
Default
priority output-priority
0 1
1 0
2 0
3 1
4 2
5 2
6 3
7 3
Example
Map the priority “0” to the output queue “2”.
xg(config)# qos-map priority 0 output-priority 2