Filter
Top Products
XG2000 series User's Guide
221/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.16.9 monitor error
Function
Displays error traffic statistics for each port.
Prompt
xg> or xg#
Command syntax
monitor error { current | total } [interval <3-60>]
Parameter
z { current | total }
Specifies the statistics to be displayed.
− current
Displays the accumulated error count after startup of this command.
− total
Displays the accumulated error count after the system startup.
If the error count reaches 4294967295, it is returned to 0 when incremented.
z interval <3-60>
Specifies the update interval (in seconds).
The default interval is 3 seconds.
Command type
Operation management command
Output form (if "current" is specified)
xg# monitor error current
Error Statistics(Current Counts) 2007/01/22-12:12:15
==================================================================================>
Port Rx Rx & Tx Rx & Tx Rx & Tx Rx & Tx Rx Total
CRC Over Under Fragment Jabber Align Lost
--- ---------- ---------- ---------- ---------- ---------- ---------- ----------
1 1234567890 1234567890 1234567890 1234567890 1234567890 1234567890 1234567890
2
123 12 34 34 56 78 90
3
123 12 34 34 56 78 90
4 123 12 34 34 56 78 90
5 123 12 34 34 56 78 90
6
123 12 34 34 56 78 90
7 123 12 34 34 56 78 90
8 123 12 34 34 56 78 90
=================================================================================>
ESC:exit F:refresh
U:page up D:page down L:page left R:page right
(continues)
Error Statistics(Current Counts) 2007/01/22-12:12:15
<======================================================================
Port-Description
------------------------------------
port_name1
port_name2
port_name3
port_name4
port_name5
port_name6
port_name7
<=======================================================================
ESC:exit F:refresh
U:page up D:page down L:page left R:page right
z Port
Displays the port numbers. Statistics for each port are displayed on one line.
z Rx CRC
Displays the accumulated number of FCS (Frame Check Sequence) error frames received after
startup of this command.
z Rx & Tx Over
Displays the accumulated number of frames whose size exceeds 1518 bytes (excluding the VLAN
tag) after startup of this command.
z Rx & Tx Under
Displays the accumulated number of transmission frames whose size is less than 64 bytes after
startup of this command.
z Rx & Tx Fragment
Displays the accumulated number of FCS (Frame Check Sequence) error frames whose size is
less than 64 bytes sent or received after startup of this command.
z Rx & Tx Jabber
Displays the accumulated number of FCS (Frame Check Sequence) error frames whose size exceeds
1518 bytes (excluding the VLAN tag) sent or received after startup of this command.