Filter
Top Products
XG2000 series User's Guide
219/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.16.8 monitor dataflow
Function
Displays statistics including both pause frame transmission to and from each port and the results of transmission processing.
Prompt
xg> or xg#
Command syntax
monitor dataflow { current | total } [interval <3-60>]
Parameter
z { current | total }
Specifies the statistics to be displayed.
− current
Displays the accumulated data count after startup of this command.
− total
Displays the accumulated data count after the system startup.
z interval <3-60>
Specifies the update interval (in seconds).
The default interval is 3 seconds.
Command type
Operation management command
Output form (if "current" is specified)
xg# monitor dataflow current
Dataflow Statistics(Current Counts) 2007/01/22-12:12:15
======================================================================>
Port Link State/ Flow-Ctl Forward Flood Rx-Pause Tx-Pause
STP State Mode Counts Counts Counts Counts
---- ------------- ------- ----------- ----------- ----------- -----------
1 Up/Discard Rx & Tx 1234567890 1234567890 1234567890 1234567890
2 Down
Rx 0 0 0 0
3 Up/Discard Rx & Tx 1234567890K 1234567890K 1234567890K 1234567890K
4 Up/Learn Rx & Tx 1234567890M 25690M 25690M 25690M
5 Up/Forward Rx & Tx 1234567890G
25690G 25690G 25690G
6 Up/Forward Rx & Tx 1234567890T 25690T 25690T 25690T
7 Down Rx 0 0 0 0
8 Down Rx 0
0 0 0
======================================================================>
ESC:exit F:refresh
U:page up D:page down L:page left R:page right
(continues)
Dataflow Statistics(Current Counts) 2007/01/22-12:12:15
<======================================================================
Full-Drop VLAN-Drop Port-Description
Counts Counts
----------- ----------- -----------------------------
1234567890 1234567890 port_name1
0
0 port_name2
1234567890K 1234567890K port_name3
25690M 25690M port_name4
25690G 25690G port_name5
25690T 25690T port_name6
0 0 port_name7
0 0
<======================================================================
ESC:exit F:refresh
U:page up D:page down L:page left R:page right
z Port
Displays the port numbers. Statistics for each port are displayed on one line.
z Link State/STP State
Displays the port state in the Link State or STP State format.
The Link State may indicate one of the following link states.
− Down
The port link is down.
− Up
The port link is up.
The STP State indicates the current port status based on the STP (Spanning Tree Protocol).
Note that the STP State is not displayed if the Link State is down.
For port status details, see “Spanning Tree Protocol Port States
”.
z Flow-Ctl Mode
Displays the flow control setup for each port.
− Rx & Tx
Both transmission and reception of pause frames are enabled.
− Rx
Only the reception of pause frames is enabled.
z Forward Counts
Displays the accumulated number of frames forwarded normally (the unicast frames received
at each port after the startup of this command).