Filter
Top Products
XG2000 series User's Guide
122/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.7.3 show bridge mac-address-table
Function
Displays the MAC address information registered in the MAC address table.
Prompt
xg> or xg#
Command syntax
show bridge mac-address-table [ { static | dynamic | igmp-snooping | port <1-20> | agg-port <1-10> |
vlan <1-4094> } ]
Parameter
z static
Displays only static MAC addresses.
z dynamic
Displays only dynamic MAC addresses.
z igmp-snooping
Displays MAC addresses registered in IGMP snooping.
z port <1-20>
Specifies the port number of the switch to display.
z agg-port <1-10>
Specifies the aggregation group number of the switch to display.
z Vlan <1-4094>
Specifies the vlan number of the switch to display.
When the parameters are omitted, all MAC addresses will be displayed.
Command type
Operation management commands
Output form
xg# show bridge mac-address-table
Mac Address Table Information 2007/01/22-12:12:15
Static Mac-address Table
------------------------------------------------------------------------
Mac-address Vlan-id Destination-port
-------------- -------- --------------------
0001.123a.4321 vlan-1 port 2
0002.123a.4321 vlan-1 port 4
0003.123a.4321 vlan-3 filter
ef01.123a.4321 vlan-3 port 1 2 3 4 5 6 7 8
Dynamic Mac-address Table
----------------------------------------------------------------
Mac-address Vlan-id Destination-port
-------------- -------- --------------------
0004.123a.4321 vlan-1 port 4
IGMP snooping learning group Mac-address Table
----------------------------------------------------------------
Mac-address Vlan-id
Destination-port
-------------- --------- -------------------------------------
(nothing)
================================================================
MAC addresses are sorted in the ascending order.
z Mac-address
The destination
MAC address is displayed.
z Vlan-id
The associated VLAN ID is displayed.
When the learning mode of the MAC address table is SVL (Shared Vlan Learning), "-------"
is displayed.
z Destination-port
The associated destination port number is displayed.
− port <1-20>
The destination port number is shown. For multicast MAC addresses, multiple port numbers
are displayed.
− filter
The MAC addresses are filtered.
Message
% IGMP snooping is not enabled.
Explanation
Since Global IGMP snooping is disabled, igmp-snooping cannot be specified.
Solution
After enabling IGMP snooping, specify igmp-snooping.