Filter
Top Products
XG2000 series User's Guide
268/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
6.1.2 Verifying System Status
Verify the system status by entering the "show system information" command in the operator EXEC mode or in the
administrator EXEC mode.
The following example shows the information that is displayed when the "show system information
" command is entered.
xg# show system information
System Information 2007/02/22-21:06:11
=======================================
System Name (hostname) : xg
System Location
: (none)
System Contact : (none)
Default Banner : XG2000 E10L11 Z01
Startup Time : 2007/02/22-19:28:24
Startup-config Modified: 2007/02/22-19:54:01
Firmware Information
Firmware[1] : E10L10 Z01 2007/01/21-18:42:52
Updated Time : 2007/01/21-22:08:12
Firmware[2] : E10L11 Z01 2007/02/22-19:27:12
Updated Time : 2007/02/23-10:57:53
Current Firmware : [2]
Next Startup Firmware
: [2]
Boot Loader : E10L10 Z01
Timezone
: gmt +0900
(Next Boot) : gmt -800
Summer-Time : (none)
(Next Boot) : M4.1.0/0200 M10.5.0/0200 0100
RS232C Baud-Rate : 9600
Management LAN Information
MAC Address : 0080.17c2.0500
IP Address/Mask : 192.168.41.22/24
Default Gateway : 192.168.41.1
DNS Server : 192.168.77.20
Domain Name : abc.efg.com
System Load Information
CPU Used Ratio
: 1%
Memory Used Size : 36,429,824 bytes (28%)
Check the version of firmware. Verify the system status based on CPU load and memory usage.
6.1.3 Reviewing Log Messages
Log messages from the device are classified into 4 levels -- CRITICAL, ERROR, WARNING, and INFO -- in accordance with
the severity of events.
To display event logs, run the "show log
" command in the operator EXEC mode or in the administrator EXEC mode.