Filter
Top Products
XG2000 series User's Guide
67/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.3 Serial/Telnet/SSH Configuration Commands
This section explains configuration commands related to a serial connection/telnet/SSH connection.
5.3.1 terminal pager
Function
Enables or disables the pager function of the serial/telnet/SSH terminal.
Prompt
xg> or xg#
Command syntax
terminal pager { on | off }
Parameter
z pager { on | off }
Specifies enable/disable of the pager.
− on
Enables the pager.
− off
Disables the pager.
Command type
Operation management commands
Default
on
Note
z This command is effective until the terminal is disconnected.
5.3.2 line
Function
Switches to the terminal edit mode
Prompt
xg(config)#
Command syntax
line console
Parameter
z console
Switches to the terminal edit mode of the serial connection.
Command type
Configuration command
Example
Switch from the administrator exec mode to the terminal edit mode with the serial interface.
xg# configure terminal
xg(config)# line console