Filter
Top Products
XG2000 series User's Guide
182/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.13.4 bridge diffserv-tos
Function
Enables Quality of Service using the DiffServ code point.
When priority control by DiffServ codes is enabled, any priority included in a VLAN tag and the default priority are ignored.
Use the no form to disable DiffServ code control.
Prompt
xg(config)#
Command syntax
bridge diffserv-tos { ipv4 | ipv6 }
no bridge diffserv-tos
Parameter
z diffserv-tos { ipv4 | ipv6 }
Enables Quality of Service using the DiffServ code point.
− ipv4
Enables IPv4 Quality of Service.
− ipv6
Enables IPv6 Quality of Service.
Command type
Configuration command
Default
None
Example
Enable Quality of Service using the DiffServ code point for IPv4.
xg(config)# bridge diffserv-tos ipv4