Filter
Top Products
XG2000 series User's Guide
58/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
5.1 About Command Reference
This section describes how to read command references.
5.1.1 Command System
The following is the system of commands provided in the device:
Item Function
Management LAN Interface Configuration
commands
These are used to configure functions related to the management LAN
interface.
Serial/telnet/SSH configuration commands These are used to configure functions related to serial, telnet and SSH
connections.
System Basic Operation commands These are necessary commands for system operation such as the
system time setting, password setting, and file operations.
Configuration Information Operation
commands
These are used for displaying or saving configuration information
(running-config and startup-config) in the device.
Switch Basic Configuration commands These are used to configure the basic functions of the device.
Link Aggregation Configuration commands These are used to create/delete aggregation groups.
Switch Port Configuration commands These are used to set the operating characteristics of each switch port.
Spanning Tree Protocol (STP) Setup
commands
These are used to configure STP (Spanning Tree Protocol).
Virtual LAN (VLAN) Configuration commands These are used to configure virtual LAN (VLAN).
Quality of Service (QoS) Setup commands These are used to configure QoS (Quality of Service) configuration.
Port Mirroring Setup commands These are used to configure port mirroring.
IGMP Snooping Setup commands These are used to configure IGMP Snooping.
Statistics commands These are used to display various operational statistics.
SNMP Configuration commands These are used to configure SNMP.
RMON Configuration commands These are used to configure RMON.
System Status Display commands These are used to display the system status of the device and the
operational status of its hardware.
Maintenance commands These are necessary for maintenance of the device.