Filter
Top Products
XG2000 series User's Guide
133/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
z Synchro State
The synchronization status of the port is displayed.
− Sync
The link state of LACP with the destination device connection is in a synchronized
state.
− No Sync
The link state of LACP with the destination device connection is not in a synchronized
state.
z Receive State
Displays the reception status of LACP protocol.
− Invalid
The LACP port destination device connection is in trouble.
− Initialize
The LACP port destination device connection is in initializing.
− Port Disabled
The LACP port of the destination device connection is disabled.
− LACP Disabled
LACP at the connection destination device is disabled.
− Expired
LACP information with for destination device connection expired.
− Defaulted
The LACP port of the destination device is about to be connected.
− Current
The LACP port of the destination device is an LACP connected state.
z Periodic Tx State
The state of the LACP transmit interval control frame is displayed.
− No Periodic
An LACP control frame will not be sent.
− Fast Periodic
LACP control frames are sent at short intervals.
− Slow Periodic
LACP control frames are sent at long intervals.
z Partner System Priority
LACP system priority will be displayed. This system priority is from the device which is
connected by a port.
z Partner System ID
LACP system ID will be displayed. This system priority is from the device which is connected
by a port.
z Partner System Key
LACP system key will be displayed. This system priority is from the device which is connected
by a port.
z Partner Port Priority
The port priority value of the connection's destination device is displayed.
z Partner Port Number
The port number of the connection's destination device is displayed.
z Partner Synchro State
The port synchronization status of the connection destination device is displayed.
− Sync
The LACP link state is synchronized.
− No Sync
The LACP link state is not synchronized.
Note
z In the case of LACP link-aggregation, make sure to confirm “Partner System Priority”, “Partner System ID”, “Partner
System Key” .are matched for each port of a LACP aggregation member. If not matched, it is necessary to connect
correctly and reissue the command.
Example
Display the state of all aggregation groups.
xg> show link-aggregation