Filter
Top Products
XG2000 series User's Guide
135/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
z distribution-parameter <0-3>
Specifies a parameter used in calculating of frame distribution method.
When this parameter is omitted, "0" is assumed.
z Under certain circumstances, load balance bias may not be resolved, when the distribution method is
changed. By changing the distribution parameter value, the bias can be minimized.
However, this value affects the distribution patterns only. Changing the value does not guarantee
resolution of frame distribution bias.
z minimum-port <1-10>
Specifies the minimum number of ports in a link up state required to maintain the link up
state of the aggregation group.
When the number of ports in a link up state within an aggregation group is less than the
minimum number of ports specified, the aggregation group changes to a link down state.
When this parameter is omitted, 1 is assumed.
z port <1-20> <1-20> [ <1-20> ]
Assigns port numbers to an aggregation group. Separate each port number with a " " (space).
Specify two or more port numbers.
Command type
Configuration command
Default
None
Message
% agg-port %1$ already exists
Explanation
An aggregation group with the same number already exists.
[[Inserted string]]%1$: specified aggregation group number
Solution
Review the specified aggregation group number, and execute the command again.
% protocol is not LACP
Explanation
Although the protocol specified was not lacp, lacp-mode was specified.
Solution
When the protocol is not lacp, do not specify lacp-mode.
% The maximum number of member ports is 10
Explanation
The number of specified ports was more than 10.
Solution
Set the number of ports to 10 or less.
% port %1$ is already member of aggregation group
Explanation
The specified port already belongs to another aggregation group.
[[Inserted string]]%1$: specified port number
Solution
Specify a port not belonging to any aggregation groups.
% Same port number is found %1$
Explanation
The duplicate port numbers were specified.
[[Inserted string]]%1$: port number duplicated
Solution
Edit the port numbers then execute the command again.
% Minimum-port is too large %1$
Explanation
The number of ports specified in minimum-port surpasses the number of ports constituting
the aggregation group.
[[Inserted string]]%1$: specified number of ports
Solution
Specify a minimum-port value equal to or less than the total number of ports within the
aggregation group. Then execute the command again.
% port %1$ is membership of uplink-domain %2$.
Explanation
The specified port already belongs to an uplink domain.
[[Inserted string]]%1$: specified port number
[[Inserted string]]%2$: uplink domain number
Solution
Specify a port not belonging to any uplink domains. Or remove the port from an uplink
domain.