IBM AS/400e Computer Hardware User Manual


 
Use the Create Authorization List (CRTAUTL) command to create an
authorization list. Use the Add Authorization List Entry (ADDAUTLE)
command to add user profile entries to the list.
For more information about how and when to use authorization lists, see
the
Tips and Tools for Securing Your AS/400
book.
Dial-Out Point-to-Point Profile Parameters:
To create a dial-out (*DIAL) profile,
enter WRKTCPPTP. AS/400 displays the Work with Point-to-Point TCP/IP display
shown in Figure 98. Enter the following:
1. Option 1 to add a profile.
2. A name for the profile.
3. *DIAL for a dial-out profile.
Figure 99, Figure 100, Figure 101, and Figure 102 show the default entries that
AS/400 displays for adding a *DIAL profile.
Work with Point-to-Point TCP/IP
Type option, press Enter.
1=Add 2=Change 3=Copy 4=Remove 5=Display details 6=Print
9=Start 10=End 12=Work with line status 14=Work with session job
Line Line Job
Opt Name Mode Type Status Description Type Name
1 EEL *DIAL
Figure 98. Add *DIAL Configuration Profile for SLIP
Add TCP/IP Point-to-Point *DIAL Profile
System: SYSNAM
Name: EEL
Text
Type choices, press Enter.
TCP/IP information:
Protocol type..........: *SLIP
Local interface address...... 1 Address, *DYNAMIC
Remote IP address......... 2 Address, *DYNAMIC
Request header compression .... Y 3 Y=Yes, N=No
Maximum transmission unit..... 576 4 576-1006
Add default route......... N 5 Y=Yes, N=No
Additional name server ...... *NONE 6 Address, *NONE
More...
F2=Change modem information F3=Exit F4=List F9=Command line
F12=Cancel
Figure 99. Creating a *DIAL Configuration Profile-Display 1
Chapter 4. Configuring Point-to-Point TCP/IP (PPP and SLIP) 147