Filter
Top Products
Working with RouteD Configuration
Use the
Work with RouteD Configuration
(WRKRTDCFG) command to change the
RouteD server configuration. The following are two different ways to get to this
command prompt:
v Specify the
Work with RouteD Configuration
command, WRKRTDCFG.
v Select option 2 on the
Configure TCP/IP RouteD
(CFGTCPRTD) display.
Note: You must have *IOSYSCFG special authority to make changes to the
RouteD configuration with the WRKRTDCFG command.
RouteD Configuration Scenario
Figure 238 on page 394 shows how the RouteD configuration entries work in a
sample network. The routers know every route within every network, including
networks X, Y, Z, A, and W.
Work with RouteD Configuration
System: SYSNAM01
Type options, press Enter.
1=Add 2=Change 3=Copy 4=Remove 5=Display 13=Insert
Sequence
Opt Number Entry
_____ 00010 #*************************** >
_____ 00020 # RTD DEFAULT CONFIGURATION >
_____ 00030 #*************************** >
_____ 00040 # >
_____ 00050 # RouteD Interface Definitions
_____ 00060 # ----------------------------
_____ 00070 # TCP/IP will learn about a route to network 9.0.0.0 th >
_____ 00080 # means external to RouteD, therefore do not allow Rout >
_____ 00090 # route to this network.
_____ 00100 #
_____ 00110 # RIP_INTERFACE * SUPPLY RIP1 METRIC 1 BLOCK 9.0.0.0 MA >
_____ 00120 #
_____ 00130 #
More...
F3=Exit F5=Refresh F6=Print List F12=Cancel F17=Top F18=Bottom
Figure 237. Work with RouteD Configuration
Chapter 15. RouteD Server 393