Filter
Top Products
CNN(*SWTPP)
Specifies that this is a switched point-to-point asynchronous line. The line
description must be specified as a switched line when using a modem.
DIALCMD(*OTHER)
Specifies that this asynchronous line is attached to a modem that uses the
Hayes AT command set. Only AT command modems are supported for use with
AS/400 TCP/IP point-to-point connection profiles. You must use this value if
SLIP is to use the asynchronous line.
SWTCNN(*DIAL)
You must specify this value when you specify DIALCMD(*OTHER).
Note: Do not confuse the value specified for SWTCNN with the operating
mode of your configuration profile. It does not matter whether line
description will be used with an operating mode *DIAL configuration
profile or a *ANS profile. You must always specify SWTCNN(*DIAL) for
the line.
AUTOANS(*NO)
Specifies that the support in AS/400 line description for automatic answering is
not used. You must specify this value when you specify SWTCNN(*DIAL).
Note: AS/400 TCP/IP Point-to-Point uses the Auto Answer Mode capability of
your modem to answer incoming calls to an *ANS Operating Mode
configuration profile. AUTOANS(*NO) does not affect the ability of
AS/400 SLIP to respond to an incoming call.
AUTODIAL(*YES)
You must specify this value when you specify DIALCMD(*OTHER).
INACTTMR(*NOMAX)
You must specify this value when you specify DIALCMD(*OTHER).
154 OS/400 TCP/IP Configuration and Reference V4R4