Filter
Top Products
Changing BOOTP Attributes
Select option 1,
Change BOOTP Attributes
,ofthe
Configure TCP/IP BOOTP
display
(or simply type CHGBPA and press F4) to display the
Change BOOTP Attributes
display. The AUTOSTART parameter controls if the BOOTP server is to start
automatically when TCP/IP is started with the STRTCP command.
Note: You must have *IOSYSCFG special authority to make changes to the
BOOTP attributes with the CHGBPA command.
Working with the BOOTP Table
Select option 2,
Work with BOOTP Table
,ofthe
Configure TCP/IP BOOTP
display
(or simply specify WRKBPTBL) to display the
Work with BOOTP Table
display.
The administrator uses the
Work with BOOTP Table
display to add, change,
remove, or display an entry in the BOOTP table.
For information about working with the BOOTP table, see
IBM Network Station
Manager for AS/400
, SC41-0632.
Adding IBM Network Stations to an Existing BOOTP Environment
This section describes how to add Network Stations to an existing BOOTP
environment. You can use either the command line interface or Operations
Navigator to add Network Stations.
Change BOOTP Attributes (CHGBPA)
Type choices, press Enter.
Autostart server........ *YES *YES, *NO, *SAME
Figure 231. Change BOOTP Attributes (CHGBPA)
Work with BOOTP Table
System: SYSNAM01
Type options, press Enter.
1=Add 2=Change 4=Remove 5=Display
Client
Host MAC IP
Opt Name Address Address
act01.ibm.com 02.01.8C.06.34.98 9.130.42.1
Figure 232. Work with BOOTP Table (WRKBPTBL)
Chapter 13. BOOTP Server 379