Filter
Top Products
c. In the Setup Utility, press F4.
d. Record the MAC address.
v IP address – Each Network Station requires a unique IP address. Therefore,
you must assign a specific address to each Network Station. You must
ensure that the IP address is valid for your organization and that no other
device in the network uses it. An example of a valid IP address is
192.168.1.2.
v Hardware type – Your Network Stations can attach to either a Token-ring or
Ethernet LAN.
– Specify a value of 6 for Token-ring or IEEE (802.3) Ethernet networks.
– Specify a value of 1 for a Version 2 (802.2) Ethernet network.
5. If you do not use Gateway IP addresses for remote LANs, leave this field blank.
Otherwise, specify the IP address of the IP router or gateway that your Network
Station uses to reach the server.
6. If you do not use a subnet mask for remote LANs, leave this field blank.
7. Verify that the following default values are correct:
v
Type
is IBM Network Station Manager.
v
File name and directory
is /QIBM/ProdData/NetworkStation/kernel.
8. Click OK.
9. Repeat steps 3 through 8 for each additional Network Station.
10. Click OK to update the BOOTP server.
Chapter 13. BOOTP Server 381