Filter
Top Products
Ending the TFTP Server
Specify the following
End TCP/IP Server
(ENDTCPSVR) command with the Server
parameter set to *TFTP:
ENDTCPSVR SERVER(*TFTP)
Changing TFTP Attributes
The
Change TCP/IP TFTP Attributes
(CHGTFTPA) command is used to change the
TFTP server attributes. The following are two different ways to get to this command
prompt:
v Specify the
Change TCP/IP TFTP Attributes
(CHGTFTPA) command.
v Select option 3 on the
Configure TCP/IP Applications
(CFGTCPAPP) display.
Note: You must have *IOSYSCFG special authority to make changes to the TFTP
attributes with the CHGTFTPA command.
Change TFTP Attributes (CHGTFTPA)
Type choices, press Enter.
Autostart server........ *NO *YES, *NO, *SAME
Enable subnet broadcast .... *YES *YES, *NO, *SAME
Number of server jobs:
Minimum ........... 2 1-20, *SAME, *DFT
Maximum ........... 6 1-250, *SAME, *DFT
Server inactivity timer .... 30 1-1440, *SAME, *DFT
ASCII single byte CCSID:
Coded character set identifier 00819 1-65532, *SAME, *DFT
Maximum block size....... 1024 512-65464, *SAME, *DFT
Connection response timeout . . 60 1-600, *SAME, *DFT
Allow file writes ....... *NONE *DFT, *NONE, *CREATE...
Alternate source directory... '*NONE'
More...
F3=Exit F4=Prompt F5=Refresh F12=Cancel F13=How to use this display
F24=More keys
Figure 233. Change TFTP Attributes (CHGTFTPA) – Display 1
Change TFTP Attributes (CHGTFTPA)
Type choices, press Enter.
Alternate target directory... '*NONE'
Figure 234. Change TFTP Attributes (CHGTFTPA) – Display 2
384 OS/400 TCP/IP Configuration and Reference V4R4