Filter
Top Products
This shows the
Work with Writers
display, from which it is necessary to press F17
to see the job log. This sequence is different from the usual one for viewing batch
and interactive job logs while the jobs are running.
Configuring for a RISC System/6000 System — Scenario
This section describes the following topics:
v How to configure LPD on the RS/6000 system to allow an AS/400 to send a
spooled file with LPR.
v How to configure device and virtual printers for AIX print output.
v How to configure a PSF/6000 printer for PSF/6000 print output.
Setting Up for LPD on the RISC System/6000 System — Scenario
Use the following series of commands to follow through the SMIT menus on the
RS/6000 system.
At the AIX command line prompt, specify the following:
smit
Spooler (Print Jobs)
Manage Remote Printer Subsystem
Server Services
Host Access for Printing
Add a Remote Host
Specify the host name of the remote host that you want to send spooled files to the
local LPD as shown in Figure 218. In this case, it is SYSNAM890. This name must
also be in the local host table of the RS/6000 system (/etc/hosts).
Configuring Device and Virtual Printer for AIX Printing
Two steps are necessary for the following configurations on the RS/6000 system.
Configuring the AIX Printer Device
To configure a non-IPDS printer so that the system recognizes it as an AIX printer,
specify the following at the AIX command line prompt (in this case, an IBM 4029
printer is attached in parallel):
smit printer
Printer/Plotter Devices
Add a Printer/Plotter
Add a Remote Host
Type or select values in entry fields.
Press Enter AFTER making all desired changes.
[Entry Fields]
* Name of Remote HOST sysnam890
F1=Help F2=Refresh F3=Cancel F4=List
Esc+5=Reset F6=Command F7=Edit F8=Image
F9=Shell F10=Exit Enter=Do
Figure 218. Add a Remote Host
356 OS/400 TCP/IP Configuration and Reference V4R4