Filter
Top Products
DLCI window 100
Models 2616RC, 3096RC & 3196RC Admin Reference Guide 8 • Frame Relay
• needIPaddr(4)—This is when the IP address needs to be entered for this DLCI.
• wait4peer(5)—In this state, the Link is waiting for the far end to synchronize.
Committed Burst (bits) (frCircuitCommitedBurst)
This specifies the committed data rate for the link in bits-per-second.
Excess Burst (bits) (frCircuitExcessBurst)
This specifies the excess data rate for the link in bits-per-second.
Throughput (bits) (frCircuitThroughput)
This specifies the throughput for the link in bits-per-second.
IP Address (FrameIPAddr)
As all of the interfaces on the T-DAC run in un-numbered mode, the IP address to enter is that of the far end
router. This is not the IP address of the T-DAC. After the IP address is entered, it will appear as a point-to-
point link in the IP routing table with this address.
Congestion (frameEnableCongestion)
This option enables or disables congestion tracking.
• enable(0)—Enables congestion tracking
• disable(1)—Disables congestion tracking