Filter
Top Products
iDSL Port Configuration window 136
Models 2616RC, 3096RC & 3196RC Admin Reference Guide 10 • iDSL (Model 3196RC)
Figure 69. Color-coded port status example
Color-coded port status indicators
The iDSL Port Status table displays colored rows (see figure 69) to indicate port status for each port. The
color-coded indications are described below:
• Green—The port is currently in dataMode(1) state. An iDSL link is established with the remote CPE. The
link is ready and able to transfer data.
• Blue—The port is operating in one of the following test modes:
- localLoop(1)
- remSerLoop(2)
- lineLoop(3)
• Yellow—The port is currently in initializing(1) state and the link establishment timer has not expired
• Orange—The port was in initializing(1) state and could not establish the iDSL link, therefore it moves to
lineDown(7) state.
• Red—The port is currently in hardware failure state (see section “Current State (idslCurrentState)” on
page 135)
Desired State (idslDesireState)
Configurable. Indicates the T-DAC operator’s current intentions for the port.
• Deactivated(0)—Default value. The T-DAC operator intends the port for future use. Use this value when
the port is not currently connected to a remote CPE modem.
• Activated(1)—The T-DAC operator intends the port to be connected to a remote CPE modem for current
active use
• Reset(2)—The T-DAC operator intends to reset the iDSL port.
Test Mode (idslTMSelection)
Configurable when the value of port State is one of the following:
• initializing(1)
• datamode(6)