Filter
Top Products
System Parameters window 264
Models 2616RC, 3096RC & 3196RC Admin Reference Guide 17 • System
• writeUserlpWan(114)—The monitor user can change all parameters—except passwords— under authenti-
cation, drop-and-insert, dial-in, IP, T1/E1, and Frame Relay links.
• writeUserlpWanSystem(242)—The monitor user can change all parameters—except passwords— under
authentication, drop-and-insert, dial-in, IP, T1/E1, Frame Relay, System, and System Log links.
• writeUserlpWanSystemUpload(498)—The monitor user can change all parameters—except passwords—
under authentication, drop-and-insert, dial-in, IP, T1/E1, Frame Relay, System, and System Log links. The
monitor user can also load firmware updates into the DACS.
Stats Refresh Rate (boxWebRefreshRate)
Specifies statistics refresh rate in seconds and minutes. The following options are available:
• none(0)—No automatic refresh
• rate10sec—Statistics refreshed every 10 seconds
• rate15sec—Statistics refreshed every 15 seconds
• rate30sec—Statistics refreshed every 30 seconds
• rate1min—Statistics refreshed every minute
• rate3min—Statistics refreshed every 3 minutes
• rate5min—Statistics refreshed every 5 minutes
Front Handle Reset
Specifies whether unlocking the front handle will cause the T-DACS to reset. The available options are:
• disable(0)—T-DACS will not reset upon unlocking the right front handle
• enable(1)—T-DACS will reset upon unlocking the right front handle
SNMP and HTTP
This portion of the System window shown in figure 144 on page 262 provides information about the SNMP ver-
sion and the HTTP accessibility.
Version (boxSnmpVersion)
This parameter selects the SNMP version number supported by this unit. Select snmpv1(1) only, SNMP2 is
not currently supported.
Superuser Password (boxSnmpMasterPassword)
This accesses the super user password for complete access and configurability of the T-DAC through SNMP
and HTTP. Up to 64 octets (characters).
Superuser Password Verification (boxSnmpVerifyMasterPassword)
This is verification for the password. It must be set before replacing the old password with the new one.
User Password (boxSnmpMonitorPassword)
This accesses the user monitoring password for read only access of certain selected information. Not all param-
eters shown using the superuser password are displayed under the user password.