Filter
Top Products
RIP Version 2 Statistics 237
Models 2616RC, 3096RC & 3196RC Admin Reference Guide 15 • RIP Version 2
– rip1Compatible (3)—rip1Compatible implies broadcasting RIP-2 updates using RFC 1058 route sub-
sumption rules
– ripVersion2 (4)—ripVersion2 implies multicasting RIP-2 updates
3. Enter the protocol version to be used for receiving RIP packets. The following choices are available:
– rip1 (1)—ripVersion 1 implies sending RIP updates compliant with RFC 1058
– rip2(2)—rip1Compatible implies broadcasting RIP-2 updates using RFC 1058 route subsumption rules
– rip1OrRip2(3)
– doNotReceive(4)
Note
Options rip2 and rip1OrRip2 imply reception of multicast packets.
4. Click on Submit Query.
Note
To delete the RIP address, click on the IP Address under the col-
umn named Address. Select Status to be invalid(2) and click on
Define.
To view and modify additional configurable parameters for the RIP address, click on the Address hyperlink to
display the RIP Version Configuration window.
RIP Version 2 Statistics
For each subnet IP address defined in the T-DAC’s RIP Version 2 table, the RIP Version 2 Statistics window
(see figure 129) displays the RIP route status and the following statistical counts:
• Bad Packets
• Bad Routes
• Sent Updates
To display the RIP Version 2 Statistics window, on the RIP Version 2 main window, click the Statistics… link.
Figure 128. RIP Version 2 Statistics window
The following sections describe the information displayed on the RIP Version 2 Statistics window.
Subnet IP Address (rip2IfStatAddress)
The IP Address of this system on the indicated subnet. For unnumbered interfaces, the value 0.0.0.N, where
the least significant 24 bits (N) is the ifIndex for the IP Interface in network byte order.